Home » Forums » Aviation photography » Rejected due to "cyan cast"
David Zhang Member Joined in June 2017 Posts: 2 |
Posted 30 June 2017 - 09:26 CET |
Hey there, Today my photo was screened and got rejected because of "cyan cast", but I could not see anything too cyan, any advices? Here is my photo, http://www.airplane-pictures.net/images/rejected-images/2017-6/923997.jpg Regards from US |
Igor Kmet Full member Joined in September 2013 Posts: 99 |
Posted 30 June 2017 - 10:58 CET |
I have to agree with screeners.
If you have good ( best is calibrated monitor) which is must for successfully postprocession, you will see cyan cast. Objectivly , when i PS on Info table you put circle -pointer ( circle should be small, lets say 10 px) on place where should be white ( topp of fuselafge) you will see C 6 % ,M 1%, Y 1%, K 0 %, which indicate you cyan ( C) cast. Ideal white is 0% for all CMYK.
If you clik in PS, Image , Autocolor, you will fix this problem . CMYK is then near 0. |
Log in to post in the forum.